System Memory for Intel® Desktop Board DP67BA

Documentation

Compatibility

000007620

08/29/2017

System memory features
The board has four DDR3 DIMM sockets arranged in two channels and supports the following memory features:

  • Two independent memory channels with interleaved mode support
  • Support for non-ECC, unbuffered, single-sided or double-sided DIMMs with x8 organization and single-sided DIMMs with x16 organization
  • 32 GB maximum total system memory (with 4 Gb memory technology)
  • Minimum total system memory: 512 MB
  • Serial Presence Detect
  • DDR3 1333 MHz and DDR3 1066 MHz SDRAM DIMMs

32-bit operating systems are limited to a maximum of 4 GB of memory. These operating systems will report less than 4 GB because of the memory used by add-in graphics cards and other system resources.

To be fully compliant with all applicable Intel® SDRAM memory specifications, the board should be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. If your memory modules do not support SPD, you will see a notification to this effect on the screen at power up. The BIOS will attempt to configure the memory controller for normal operation.

1.5 V is the recommended and default setting for DDR3 memory voltage. The other memory voltage settings in the BIOS Setup program are provided for performance tuning purposes only. Altering the memory voltage may (i) reduce system stability and the useful life of the system, memory, and processor; (ii) cause the processor and other system components to fail; (iii) cause reductions in system performance; (iv) cause additional heat or other damage; and (v) affect system data integrity.

Intel has not tested and does not warranty the operation of the processor beyond its specifications. For information on the processor warranty, refer to Processor Warranty Information.

Supported memory configurations

 
DIMM Capacity Configuration SDRAM Density SDRAM Organization Front-side/Back-side Number of SDRAM Devices
512 MB Single-sided 1 Gbit 64 M x 16 / empty 4
1 GB Single-sided 1 Gbit 128 M x 8 / empty 8
1 GB Single-sided 2 Gbit 128 M x 16 / empty 4
2 GB Double-sided 1 Gbit 128 M x 8 / 128 M x 8 16
2 GB Single-sided 2 Gbit 128 M x 16 / empty 8
4 GB Double-sided 2 Gbit 256 M x 8 / 256 M x 8 16
4 GB Single-sided 4 Gbit 512 M x 8 / empty 8
8 GB Double-sided 4 Gbit 512 M x 8 / 512 M x 8 16
 

Third-party tested memory

Computer Memory Test Labs* (CMTL) tests third-party memory for compatibility with Intel® boards as requested by memory manufacturers. See the CMTL tested memory list for the Intel® Desktop Board DP67BA.