Article ID: 000076457 Content Type: Error Messages Last Reviewed: 03/08/2023

Error: Export Address/Command parity error indicator cannot be used if Addr/CMD parity latency is disabled. Addr/CMD parity latency is controlled in the Mode Register Settings section of the Memory tab (advanced setting).

Environment

  • Intel® Quartus® Prime Pro Edition
  • Memory Interfaces and Controllers
  • BUILT IN - ARTICLE INTRO SECOND COMPONENT

    Critical Issue

    Description

    Due to a problem in the Intel® Quartus® Prime Pro Edition Software version 20.3, you may see this error when you turn on the “Export Address/Command parity error indicator” option in the Intel Agilex® 7 FPGA DDR4 EMIF IP.

    Resolution

    Generate the Intel Agilex® 7 FPGA DDR4 EMIF IP without the “Export Address/Command parity error indicator” option turned on.

    Open the IP file ( .ip ) with a text editor and enable the “AC_PARITY_LATENCY” setting with valid values.

    Change from:

                  <ipxact:value>DDR4_AC_PARITY_LATENCY_DISABLE<ipxact:value>

    To:

                  <ipxact:value>DDR4_AC_PARITY_LATENCY_4<ipxact:value>  

     

    The valid AC_PARITY_LATENCY values are 4, 5, 6, and 8.

     

    Refer to the memory vendor datasheet for more details on the address/command parity latency value to apply.

    Then, regenerate the IP with the option “Export Address/Command parity error indicator” turned on.

    Additional information

    This problem is fixed starting with the Intel® Quartus® Prime Pro Edition Software version 20.4.

    Related Products

    This article applies to 1 products

    Intel Agilex® 7 FPGAs and SoC FPGAs