Stratix V Avalon-ST Interface for PCIe Solutions: User Guide

ID 683093
Date 5/03/2019
Public
Document Table of Contents

7.1.1. MSI and Legacy Interrupts

The IP core generates single dword Memory Write TLPs to signal MSI interrupts on the PCI Express link. The Application Layer Interrupt Handler Module app_msi_req output port controls MSI interrupt generation. When asserted, it causes an MSI posted Memory Write TLP to be generated. The IP core constructs the TLP using information from the following sources:
  • The MSI Capability registers
  • The traffic class (app_msi_tc)
  • The message data specified by app_msi_num
To enable MSI interrupts, the Application Layer must first set the MSI enable bit. Then, it must disable legacy interrupts by setting the Interrupt Disable, bit 10 of the Command register.

The Application Layer Interrupt Handler Module also generates legacy interrupts. The app_int_sts signal controls legacy interrupt assertion and deassertion.

Figure 35. Interrupt Handler Module in the Application Layer

The following figure illustrates a possible implementation of the Interrupt Handler Module with a per vector enable bit. Alternatively, the Application Layer could implement a global interrupt enable instead of this per vector MSI.

Figure 36. Example Implementation of the Interrupt Handler Block

There are 32 possible MSI messages. The number of messages requested by a particular component does not necessarily correspond to the number of messages allocated. For example, in the following figure, the Endpoint requests eight MSIs but is only allocated two. In this case, you must design the Application Layer to use only two allocated messages.

Figure 37. MSI Request Example

The following table describes three example implementations. The first example allocates all 32 MSI messages. The second and third examples only allocate 4 interrupts.

Table 61.  MSI Messages Requested, Allocated, and Mapped

MSI

Allocated

32

4

4

System Error

31

3

3

Hot Plug and Power Management Event

30

2

3

Application Layer

29:0

1:0

2:0

MSI interrupts generated for Hot Plug, Power Management Events, and System Errors always use Traffic Class 0. MSI interrupts generated by the Application Layer can use any Traffic Class. For example, a DMA that generates an MSI at the end of a transmission can use the same traffic control as was used to transfer data.

The following figure illustrates the interactions among MSI interrupt signals for the Root Port. The minimum latency possible between app_msi_req and app_msi_ack is one clock cycle. In this timing diagram app_msi_req can extend beyond app_msi_ack before deasserting. However, app_msi_req must be deasserted before or within the same clock as app_msi_ack is deasserted to avoid inferring a new interrupt.

Figure 38. MSI Interrupt Signals Timing