Intel® Quartus® Prime Pro Edition User Guide: Partial Reconfiguration

ID 683834
Date 7/31/2023
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

3.3.8.1. PR Control Block and CRC Block VHDL Component Declaration

The following example shows manual instantiation of the PR control block and the CRC block in your Intel® Arria® 10 PR design:
  1. Use the code sample below, containing the component declaration in VHDL. This code performs the PR function from within the core (code block within Core_Top).
    module Chip_Top is port (
    	--User I/O signals (excluding signals that relate to PR)
    	..
    	..
    )
    -- Following shows the connectivity within the Chip_Top module
    Core_Top : Core_Top
    port_map (
    	..
    	..
    );
    
    m_pr : twentynm_prblock
    port map(
    	clk => dclk,
    	corectl =>'1', --1 - when using PR from inside
    	--0 - for PR from pins; You must also enable
    	-- the appropriate option in Quartus Prime settings
    	prrequest => pr_request,
    	data => pr_data,
    	error => pr_error,
    	ready => pr_ready,
    	done => pr_done
    );
    
    m_crc : twentynm_crcblock
    port map(
    	shiftnld => '1', --If you want to read the EMR register when
    	clk => dummy_clk, --error occurrs, refer to AN539 for the
    	--connectivity forthis signal. If you only want
    	--to detect CRC errors, but plan to take no
    	--further action, you can tie the shiftnld
    	--signal to logical high.
    	crcerror => crc_error
    );
    Note: This VHDL example is adaptable for Verilog HDL instantiation.
  2. Add additional ports to Core_Top to connect to both components.
  3. Follow these rules when connecting the PR control block to the rest of your design:
    • Set the corectl signal to ‘1’ (when using partial reconfiguration from core) or to ‘0’ (when using partial reconfiguration from pins).
    • The corectl signal must match the Enable PR pins option setting in the Device and Pin Options dialog box (Assignments > Device > Device and Pin Options).
    • When performing partial reconfiguration from pins, the Fitter automatically assigns the PR unassigned pins. Assign all the dedicated PR pins using Pin Planner ( Assignments > Pin Planner) or Assignment Editor (Assignments > Assignment Editor).
    • When performing partial reconfiguration from the core logic, connect the prblock signals to either core logic or I/O pins, excluding the dedicated programming pin, such as DCLK.