Arria V Hard Processor System Technical Reference Manual

ID 683011
Date 12/02/2022
Public
Document Table of Contents

24.4.1. Initialization

To initialize the timer, perform the following steps: †

  1. Initialize the timer through the timer1controlreg register: †
    • Disable the timer by writing a 0 to the timer1 enable bit (timer1_enable) of the timer1controlreg register. †
    Note: Before writing to a timer1 load count register (timer1loadcount), you must disable the timer by writing a 0 to the timer1_enable bit of the timer1controlreg register to avoid potential synchronization problems. †
    • Program the timer mode—user-defined count or free-running—by writing a 0 or 1, respectively, to the timer1 mode bit (timer1_mode) of the timer1controlreg register. †
    • Set the interrupt mask as either masked or not masked by writing a 1 or 0, respectively, to the timer1_interrupt_mask bit of the timer1controlreg register. †
  2. Load the timer counter value into the timer1loadcount register. †
  3. Enable the timer by writing a 1 to the timer1_enable bit of the timer1controlreg register. †